Indian Journal of Dental ResearchIndian Journal of Dental ResearchIndian Journal of Dental Research
HOME | ABOUT US | EDITORIAL BOARD | AHEAD OF PRINT | CURRENT ISSUE | ARCHIVES | INSTRUCTIONS | SUBSCRIBE | ADVERTISE | CONTACT
Indian Journal of Dental Research   Login   |  Users online: 487

Home Bookmark this page Print this page Email this page Small font sizeDefault font size Increase font size         

 


 
SHORT COMMUNICATION Table of Contents   
Year : 2019  |  Volume : 30  |  Issue : 1  |  Page : 127-129
CAD/CAM system influence marginal fit of different ceramic types?


1 School of Dentistry, Graduate Program of Dentistry, University of Western São Paulo, Presidente Prudente, Brazil
2 School of Dentistry, Postgraduate Program of Dentistry, University of Western São Paulo, Presidente Prudente, Brazil
3 School of Dentistry, Graduate Program of Dentistry; School of Dentistry, Postgraduate Program of Dentistry, University of Western São Paulo, Presidente Prudente, Brazil

Correspondence Address:
Dr. Andressa Restani
Rua Dr. Arthur Falcone, 796 – Centro, Presidente Bernardes/São Paulo 19300-000
Brazil
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/ijdr.IJDR_77_18

Rights and Permissions

Objective: This study aimed to evaluate the marginal fit of zirconia and lithium disilicate ceramic restorations processed by computer-aided design (CAD)/computer-aided manufacturing (CAM) system. Materials and Methods: Ten models were prepared from a metal die, on which scanning was carried out to obtain the virtual model for the processing of zirconia and lithium disilicate ceramics using the CAD/CAM technique. Gypsum models were fabricated and used for scanning the restorations. The infrastructures were designed using software, and CAD/CAM was used to fabricate the restorations (n = 10). The analysis of the marginal discrepancy was measured at 12 points of the margin using the original metallic die. For each crown, an arithmetic average of the discrepancy values was obtained. Results: The marginal fit of the copings of lithium disilicate was 133.10 ± 26.87 μm and zirconia was 127.34 ± 47.97 μm. There was no statistically significant difference (P = 0.7709) between the materials. Conclusion: The marginal fit is similar between lithium disilicate and zirconia ceramics milled in the CAD/CAM system used.


[FULL TEXT] [PDF]*
Print this article     Email this article

 
 Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
  Citation Manager
 Access Statistics
  Reader Comments
  Email Alert *
  Add to My List *
 
 

 Article Access Statistics
    Viewed326    
    Printed14    
    Emailed0    
    PDF Downloaded14    
    Comments [Add]    

Recommend this journal